Radio Thermostat CT30 User Manual download pdf (Page 2)

Getting Started:

Examine your CTxx thermostat and identify an empty U-Snap receptacle. (refer to

your CTxx instruction manual for details).

Insert the RTZW-01 module into the CTxx receptacle with the label on the RTZW-01

facing the wall behind the CTxx thermostat.

The RTZW-01 module should slide in and engage with no visible protrusion from the

CTxx thermostat.

Once the module is seated, locate the reset button on your CTxx (see thermostat

documentation) and reset the CTxx by pressing the reset button for 1 second.

During reset you should see a “radio tower” icon appear on your CTxx along with

some beeps indicating that the CTxx thermostat is initializing the RTZW-01 U-Snap

module. When the beeping finishes (about 10 seconds), your CTxx thermostat will

be ready to join and be controlled by a Z-wave network.

Network Inclusion/Exclusion:

1.Set your primary controller to INCLUDE mode, to add the thermostat as a node on

your network (see your specific controller’s User Manual for detailed instructions.)

2. Press and release the MENU button on the thermostat.

3, Press the Mate Button - This will bring you to the network joining screen .

4. If you only have 1 U-SNAP module inserted in the thermostat you will see a r1 or

r2 to indicate that the radio is in slot 1 or slot 2. If you have multiple radios you

can select which radio you want to join the network by selecting either r1 or r2

from the top left hand corner of the screen. When you have selected a radio, the

large r1 or r2 will appear in the center of the screen.

5. When the radio is selected and the large r1 or r2 is on the center of the screen,

press the mate button, this will initiate the mating process. When a device has

joined a network the word «LINK» will appear under the radio tower. Similarly,

when you are trying to leave a network, the word «LINK» will disappear when the

node has successfully left the network.

Your controller will indicate the thermostat was successfully added to its network

(see your specific controller’s User Manual for details.)

For other controller specific tasks such as adding the thermostat to Scenes or

Groups, or deleting the thermostat as a node, use the mate button to activate the Z-

Wave® signal.

Operation:

See your specific controller’s User Manual for detailed instructions on operating your

thermostat. If your controller supports full thermostat device class functions then the

following remote features are available:

a) Up and Down Temperature Control.

b) Change between HEAT and COOL modes.

1 2 3 4 5

No comments

Radio Thermostat CT30 User Manual Page 2